Hi,
Stupid question. Does anyone know if brassark/Reeves mouthpiece threads are compatible with any other makers?
Brassark/Reeves threads?
-
- Posts: 9
- Joined: Sat Jul 07, 2018 9:20 am
- Doug Elliott
- Posts: 3380
- Joined: Wed Mar 21, 2018 10:12 pm
- Location: Maryand
Re: Brassark/Reeves threads?
I am pretty sure they are not.
"I know a thing or two because I've seen a thing or two."
- Burgerbob
- Posts: 5068
- Joined: Mon Apr 23, 2018 8:10 pm
- Location: LA
- Contact:
-
- Posts: 1029
- Joined: Tue May 08, 2018 2:05 am
- Location: Los Angeles, California
Re: Brassark/Reeves threads?
You can have any makers threads put on. It just needs to be custom ordered.
I think the stock threads Bob Reeves uses don't match anything else.
I think the stock threads Bob Reeves uses don't match anything else.
Rath R1, Elliott XT
Rath R3, Elliott XT
Rath R4, Elliott XT
Rath R9, Elliott LB
Minick Bass Trombone, Elliott LB
Rath R3, Elliott XT
Rath R4, Elliott XT
Rath R9, Elliott LB
Minick Bass Trombone, Elliott LB
-
- Posts: 100
- Joined: Fri Mar 23, 2018 7:34 am
Re: Brassark/Reeves threads?
Threads matching is one thing. The cup diameter, shape, etc... is a whole other ballgame...
-
- Posts: 1029
- Joined: Tue May 08, 2018 2:05 am
- Location: Los Angeles, California
Re: Brassark/Reeves threads?
I could have been a little clearer in my post...
I talked to Noah after ITF 2017 about getting a CV piece made that had Elliott LB threads. I never did get around to buying the piece... Noah said getting LB threads was possible but Reeves would need to custom make a piece that had the correct specs (cup diameter ect.) to fit the Elliott LB threads.
Bob Reeves is a full on custom shop, they are more then happy to make a truly custom mouthpiece, you just have to tell them what you want!
Rath R1, Elliott XT
Rath R3, Elliott XT
Rath R4, Elliott XT
Rath R9, Elliott LB
Minick Bass Trombone, Elliott LB
Rath R3, Elliott XT
Rath R4, Elliott XT
Rath R9, Elliott LB
Minick Bass Trombone, Elliott LB