Rebending an F valve lever

Post Reply
ttf_wgwbassbone
Posts: 0
Joined: Sat Mar 31, 2018 11:59 am

Rebending an F valve lever

Post by ttf_wgwbassbone »

I have an F lever made of aluminum that was bent too far out for my thumb to comfortably reach the wooden thumb paddle. Any chance I can remove the wooden piece from the lever, heat it up, straighten it out, and re-bend in a different spot?? What can possibly go wrong?  Image
ttf_bonearzt
Posts: 0
Joined: Sat Mar 31, 2018 12:00 pm

Rebending an F valve lever

Post by ttf_bonearzt »

The aluminum will probably snap,  even with heat.  Unfortunately...

Maybe get another one made from nickel or steel rod?



Eric

ttf_wgwbassbone
Posts: 0
Joined: Sat Mar 31, 2018 11:59 am

Rebending an F valve lever

Post by ttf_wgwbassbone »

Quote from: bonearzt on Nov 29, 2017, 10:06AMThe aluminum will probably snap,  even with heat.  Unfortunately...

Maybe get another one made from nickel or steel rod?



Eric


And SNAP it did! But because it was so long to begin with I was able to use what was left and re-bend to the proper length. But YES a new lever will be in my future.
ttf_wgwbassbone
Posts: 0
Joined: Sat Mar 31, 2018 11:59 am

Rebending an F valve lever

Post by ttf_wgwbassbone »

Quote from: bonearzt on Nov 29, 2017, 10:06AMThe aluminum will probably snap,  even with heat.  Unfortunately...

Maybe get another one made from nickel or steel rod?



Eric


And SNAP it did! But because it was so long to begin with I was able to use what was left and re-bend to the proper length. But YES a new lever will be in my future.
Post Reply

Return to “Repairs, Modifications, and Maintenance”