Page 1 of 1
Allen wrench for Conn 88H Gen2 and 62H Gen2
Posted: Wed Jul 16, 2025 6:49 pm
by ddsbstrb
Would any of you repair techs happen to know what size Allen wrench works on the set screws on the valve lever/levers on the Conn Gen2 88H and the Gen2 62H. My Allen wrenches are too big or too small.
Thanks for the information.
Re: Allen wrench for Conn 88H Gen2 and 62H Gen2
Posted: Thu Jul 17, 2025 1:56 pm
by Bonearzt
Hi Denny, they're either 5/64" or 3/32"
More than likely 5/64 and the head is stripped from the screw being too small to adequately tighten the lever.
Best to have the screw tapped out to 3/32" and use a larger screw.
Re: Allen wrench for Conn 88H Gen2 and 62H Gen2
Posted: Thu Jul 17, 2025 2:16 pm
by ddsbstrb
Thank you very much, Eric! Good to hear from you!
Re: Allen wrench for Conn 88H Gen2 and 62H Gen2
Posted: Fri Jul 25, 2025 12:41 am
by ddsbstrb
I finally got a complete set of Allen wrenches, and it looks like it is a 1/16 wrench which fits the Conn Allen Screws.
Re: Allen wrench for Conn 88H Gen2 and 62H Gen2
Posted: Fri Jul 25, 2025 3:01 pm
by Posaunus
I presume that these are "standard" (SAE), not metric set screws?