Greenhoe valve disassembly and cleaning

Post Reply
ChadA
Posts: 150
Joined: Tue Dec 04, 2018 5:27 pm
Location: Dayton, OH
Contact:

Greenhoe valve disassembly and cleaning

Post by ChadA »

I’ve taken regular rotors apart for cleaning many times. I now have a tenor with a Greenhoe valve. Before I think about pulling it apart, what do I need to know? How different is it from other rotors? I’m most familiar with Shires rotors.
MTbassbone
Posts: 463
Joined: Sat Apr 21, 2018 3:08 pm
Location: Silver Spring, MD

Re: Greenhoe valve disassembly and cleaning

Post by MTbassbone »

I don't think there are major differences other than the tolerances might be tighter than a standard rotor. Mine was from more than 20 years ago so I don't know if there were changes.
User avatar
paulyg
Posts: 684
Joined: Thu May 17, 2018 12:30 pm

Re: Greenhoe valve disassembly and cleaning

Post by paulyg »

There are two separate bearing plates, rather than just one found on most rotors. With rotors designed like this (the Instrument Innovations rotor is another), it is CRITICAL to get both bearing plates seated. Otherwise, the spindles will not line up, and the rotor will bind, possibly damaging it. There should be no rubbing on the casing. If you hear a swooshing noise, tap the bearing plates in further.
Paul Gilles
Aerospace Engineer & Trombone Player
brassmedic
Posts: 965
Joined: Fri Dec 14, 2018 12:07 pm
Contact:

Re: Greenhoe valve disassembly and cleaning

Post by brassmedic »

I would say don't even bother removing the back bearing plate. Just leave it as it is and take off just the front bearing plate as you would with a normal rotary valve.
Brad Close Brass Instruments - brassmedic.com
Post Reply

Return to “Maintenance”