Page 1 of 1
Brassark/Reeves threads?
Posted: Thu Jul 26, 2018 8:55 pm
by billyball
Hi,
Stupid question. Does anyone know if brassark/Reeves mouthpiece threads are compatible with any other makers?
Re: Brassark/Reeves threads?
Posted: Thu Jul 26, 2018 8:59 pm
by Doug Elliott
I am pretty sure they are not.
Re: Brassark/Reeves threads?
Posted: Thu Jul 26, 2018 10:05 pm
by Burgerbob
You can ask for them to be.
Re: Brassark/Reeves threads?
Posted: Fri Jul 27, 2018 12:51 am
by mrdeacon
You can have any makers threads put on. It just needs to be custom ordered.
I think the stock threads Bob Reeves uses don't match anything else.
Re: Brassark/Reeves threads?
Posted: Fri Jul 27, 2018 5:38 am
by Walleye
Threads matching is one thing. The cup diameter, shape, etc... is a whole other ballgame...
Re: Brassark/Reeves threads?
Posted: Fri Jul 27, 2018 10:06 am
by mrdeacon
Walleye wrote: ↑Fri Jul 27, 2018 5:38 am
Threads matching is one thing. The cup diameter, shape, etc... is a whole other ballgame...
I could have been a little clearer in my post...
I talked to Noah after ITF 2017 about getting a CV piece made that had Elliott LB threads. I never did get around to buying the piece... Noah said getting LB threads was possible but Reeves would need to custom make a piece that had the correct specs (cup diameter ect.) to fit the Elliott LB threads.
Bob Reeves is a full on custom shop, they are more then happy to make a truly custom mouthpiece, you just have to tell them what you want!